Samsung SCX-8030ND Series Service Manual page 320

● Code :
C1-1411
● Symptom / Cause :
The data of CRUM is not detected.
1. Toner cartridge is not placed in the set.
2. Physical obstacle is jamming the electronic signal th
3. The signal from set is not proper.
● Troubleshooting method :
1. Open the front cover. O f
Remove the waste toner container.
2. Is the toner cartridge placed in the set or not?
YES! NO! → Place the toner cartridge in the set
↓
Pull out the imaging unit and check the modular ja Pull out the imaging unit and check the modular ja
Is there any contaminations or obstacles?
YES! NO! → Is the modular jack fixed in proper p
↓ YES!
↓ ↓
↓ Check whether the electronic signal is
↓
Sweep the contaminations or remove the obstacles
Install the toner cartridge and do the reverse of No
Is there the error message?
YES! NO! → It's done.
↓
Check whether the electronic signal is proper or no
● Replacement part
- JC92-02302A : PBA-ENGINE (SCX-8030ND) JC92 02302A : PBA ENGINE (SCX 8030ND)
- JC92-02221A : PBA-ENGINE (SCX-8040ND)
Service Manual
SCX-8030/8040 series
7.Troubles
● Error message :
Toner cartridge is no
NO! → Replace the toner cart
shooting
:
ot installed. Install the cartridge.
hrough the modular jack.
.
ack. ack.
position?
tridge with new one.
s proper or not.
s.
.1.
ot. Check the connector and engine board.
7-2 27
SAMSUNG ELECTRONICS
Version 0.05