Samsung SCX-8030ND Series Service Manual page 191

6. Push up the steel frames, and tighten the three scre
7. Make sure the two rubber pads (left side) and two p 7 M k th t
DADF on both sides touch the top of the machine as
CAUTION - If you skip this step, it could cause origina
CAUTION - If the gap is more than 0.5 mm (0.02 inch)
the gap is smaller 0.5 mm (0.02 inch). You have to che
Service Manual
SCX-8030/8040 series
3.Replacemen
bb d (l ft id )
nt Procedure
ews.
d t plastic projections (right side) on the bottom of the l ti j ti
s shown below.
als to jam.
), adjust the screw on both sides as shown below until
eck all rubber pads and plastic projections.
3-8 81
( i ht id ) th b tt
SAMSUNG ELECTRONICS
f th
Version 0.05