Samsung SCX-8030ND Series Service Manual page 335

● Code :
H1-1352
H1-1452
M1-5112
M1-5212 M1 5212
● Symptom / Cause :
Tray No. LED is on.
- Paper is empty in tray or the actuator empty is broken
● Troubleshooting method :
1. Take out Tray 1(2,3,4) cassette.
2. Load the paper.
3. Adjust the paper align guide.
4. Insert Tray 1(2,3,4) cassette.
If paper is loaded but error message is not disappeare
1. Check if the actuator empty of the pick up unit is bro
Reassemble or reconnect the actuator empty.
2. Check if the empty sensor connector of the pick up u p y
Reconnect it.
3. Check if the junction connector of the pick up unit is
Reconnect or replace it.
4. Check if the Joint PBA connector is connected prop
R Reconnect it or replace the Joint PBA. t it l
5. Check if the paper REGI. connector on the engine c
6. Replace the engine controller PBA.
● Replacement part ● Replacement part
- 0604-001393 : PHOTO-INTERRUPTER
- JC92-02233A : SIDE JOINT
- JC92-02302A : PBA-ENGINE (SCX-8030ND)
- JC92-02221A : PBA-ENGINE (SCX-8040ND)
Service Manual
SCX-8030/8040 series
7.Troubles
● Error message :
Paper is empty in tra
Paper is empty in tra
Paper is empty in tra
Paper is empty in tra P i t i t
p
th J i t PBA
shooting
ay 3. Load paper
ay 4. Load paper
ay 1. Load paper
ay 2. Load paper 2 L d
n.
ed, check the following.
oken or broken away.
p unit is connected properly. p p
connected properly.
erly.
controller is connected properly. Reconnect it.
7-4 42
y
SAMSUNG ELECTRONICS
Version 0.05