Sena Promi-SD 101 User Manual page 46

Promi-SD User Manual – Appendix A. AT Commands
Description
Reference
25 AT+BTNAME=$string
SD Response
Purpose
Parameters
Description
Reference
Example
26 AT+BTLPM,n
SD Response
Purpose
Parameters
Description
27 AT&V
SD Response
Purpose
Description
Reference
28 ATSnn? 
SD Response
Purpose
Parameters
Description
Reference
29 ATSnn=mm
SD Response
If the authentication is activated, the pin code must be set by AT+BTKEY command.
Data encryption cannot be used when authentication is not activated, i.e.
Authentication=0 and Encryption=1 is not valid.
AT+BTCSD, AT+BTFP, AT+BTSD?, AT+BTSD?, ATZ, AT&F
 OK
Change device name
$string= New device name (Default="PSDv3b-445566")
Promi -SD can have a user friendly name to identify easily. The name allows 30 alpha-
numeric characters maximum.
AT+BTINFO?, AT+BTINQ?
AT+BTNAME="My-Promi-SD"
 OK
Set low power mode
n=0: Inactivate (Default)
n=1: Activate
During no data transmission, Promi -SD can be in low power mode to save the power
consumption. It takes a few seconds to wake up Promi-SD in low power mode.
 S0:m0;S1:m1; ...Sn:mn
 OK
Display all the S-register
All parameters are stored at S-register in flash memory. These values are sustained until
hardware reset.
ATS
 value
 OK
Display a given S-register
nn= Address of S-register
A specific S-register is displayed.
AT&V
 OK
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
A-10