Sena Promi-SD 101 User Manual page 44

Promi-SD User Manual – Appendix A. AT Commands
Purpose
Parameters
Description
Reference
Example
17 ATD
SD Response
Purpose
Description
Reference
18 ATD112233445566
SD Response
Purpose
Parameters
Description
Reference
Example
19 ATH
SD Response
Purpose
Description
Reference
Wait for connection by the Bluetooth device with given BD address
112233445566=BD address
to= time duration in seconds
For the given to, Promi-SD is waiting for the connection from the Bluetooth device with
the given BD address. If the parameter of to is 0, it will wait forever.
When connection is made with the Bluetooth device, SD response will be 'CONNECT'
with its BD address. If there is no connection made within this time duration, SD response
is 'ERROR' and the operation status becomes to 'Standby'.
ATD, AT+BTINQ?, AT+BTCANCEL
AT+BTSCAN000B530011FF,30
 OK
 CONNECT 112233445566
or
 OK
 ERROR 
Connect to the last connected Bluetooth device
Promi -SD saves the BD address of the Bluetooth device most recently connected. ATD
can make connection to it without input its BD address.
If it fails to make connection, SD response is 'ERROR'.
AT+BTINQ?, AT+BTSCAN
 OK
 CONNECT 112233445566
or
 OK
 ERROR 
Connect to the Bluetooth device with given BD address
112233445566=BD address
Promi -SD attempts to connect to the Bluetooth device with the given BD address. To
make successful connection, the Bluetooth device must be in Page scan. This attempt
continues for 5 minutes.
If it fails to make connection, SD response is 'ERROR'.
AT+BTINQ?, AT+BTSCAN
ATD000B530011FF
 OK
 DISCONNECT
Release the current connection
The current Bluetooth connection is released normally. It takes about 30 seconds to
detect an abnormal disconnection such as power off and moving out of service range.
ATD, AT+BTSCAN
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
A-8