Upgrade Fail - IOGear GCS1808 Installation Manual

Upgrade Fail

If you don't see "Firmware upgrade OK" in the
"Status Messages" window, it means the utility has
failed to complete the firmware successfully. If that
occurs, please do the following:
Step 1
Unplug the power from the KVM. Then, connect
the provided firmware upgrade cable to the
firmware upgrade port of the KVM and the serial
port of your computer.
Step 2
Slide the Firmware Upgrade Recovery Switch
to the Recover position (slide to the right). Then,
connect power adapter back to the KVM.
Step 3
Repeat the firmware upgrade process. (Please refer
to Firmware Upgrade section)
Step 4
After the firmware upgrade has completed, the KVM
will reset itself. Unplug the power from the KVM
after the KVM is reset.
Step 5
Slide the Firmware Upgrade Recovery Switch back
to the Normal position (slide to the left). Then,
connect power adapter back to the KVM.
Final Step
Now the KVM is ready to function again, so you
simply reconnect all your computers and console
back to the KVM and begin using the KVM.
59