IOGear GCS1808 Installation Manual page 51

Invoke HSM, then press [←]
Invoke HSM, then press [→]
Invoke HSM, then press [b]
Invoke HSM, then press [X*] [Y*]
[Enter]
Invoke HSM, then press [r] [Enter]
Invoke HSM, then press [a] [Enter]
or
Invoke HSM, then press [q] [Enter]
*Note: X and Y are intervals from 1-8 (for GCS1808) and 1-16 (for GCS1716). When you enter, please
make sure you enter each of them as a 2 digit number, for example, you would need to type 01 for port 1.
Invokes Skip mode and skips from the current port to the first
accessible port previous to it
Invokes Skip mode and skips from the current port to the next
accessible port
Toggle hotkey beepers on or off
Switches KVM focus to the computer that is connected to Port X
in the 1st Level and Port Y in the 2nd Level
Note: If you only have a single level installation, simply ignore the
Y interval
Restore default settings (Administrator ONLY)
Invoke Auto Scan Mode
Note: Auto Scan can be paused and resume by pressing [p] or
by a single left-click on the mouse
51