Page 1
OPERATION AND PARTS MANUAL HPHA36C5H WALK-BEHIND TROWEL Revision #3 (07/06/10) To find the latest revision of this publication, visit our website at: www.multiquip.com THIS MANUAL MUST ACCOMPANY THE EQUIPMENT AT ALL TIMES. P/N 21652...
Page 2
Engine exhaust some its constituents, and some dust created by power sanding, sawing, grinding, drillingandotherconstructionactivities contains chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. Some examples of these chemicals are: Leadfromlead-basedpaints. Crystallinesilicafrombricks. Cementandothermasonryproducts.
Blades and Arm Adj. Fixture Assembly ....58-59 Lifting Bail Assembly (Option) ......60-61 Specification and part number NOTE are subject to change without notice PAGE 4 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Page 5
NOTE PAGE HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 5...
P n i f h s i i t f i i h c r o t Operator _________________________________________ Trainee __________________________________________ COMMENTS: PAGE 6 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
HPHA36C5H TROWEL— DAILY PRE-OPERATION CHECKLIST DAILY PRE-OPERATION CHECKLIST . l e e L . l e v i t i d t i P o i t COMMENTS: HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 7...
Potential hazards associated with HPHA36C5H TROWEL operation will be referenced with Hazard Symbols which appear throughout this manual, and will be referenced in conjunction with Safety Message Alert Symbols. PAGE 8 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Page 9
CAUTI CAUTI CAUTION CAUTI CAUTI This walk-behind trowel, other property, or the surrounding environment could be damaged if you do not follow instructions. HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 9...
■ Topping-off to filler port is dangerous, as it tends to spill fuel. ■ NEVER use fuel as a cleaning agent. PAGE 10 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Page 11
■ Tighten fuel tank cap securely and close fuel cock to prevent fuel from spilling. ■ Drain fuel when transporting trowel over long distances or bad roads. HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 11...
HPHA36C5H TROWEL— OPERATION AND SAFETY DECALS OPERATION AND SAFETY DECALS The HPHA36C5H walk-behind trowel is equipped with a number of operation, safety and maintenance decals. Should any of these decals become unreadable, replacements can be obtained from your dealer. CAUTION...
. The spider has 4 arms that extend outward that are used for attachment of blades or other accessories. Remember as the gearbox output shaft rotates so does the spider assembly. HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 13...
Values were obtained from all three axes of motion. The may vary depending upon the condition of the concrete. values shown represent the maximum RMS value from Hearing protection is always recommended. these measurements. PAGE 14 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
HPHA36C5H TROWEL— CONTROLS AND COMPONENTS Figure 3. HPHA36C5H Walk-Behind Trowels PAGE 16 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Page 17
These blades are versatile and should take care of most troweling needs. In addition float discs can be attached to the trowel arms that will allow the trowel to float on "wet" concrete. HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 17...
Add oil through this filler port as the starter grip until resistance is felt, then pull briskly and recommended in Table 3. smoothly. PAGE 18 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Considerable force may be required when moving the Quick- NOTE Pitch ™ pitch handle forward or CABLE HOUSING backward. CLAMP CABLE HOUSING Figure 8. Throttle Cable Connection HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 19...
Page 20
(Figure 13). Thread the second brass set nut towards the cable as far as possible. Figure 10. Engine Safety Stop Wire Connection PAGE 20 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Page 21
TIGHTEN SECOND BRASS SET NUT USE A WRENCH TO AGAINST YOKE BOSS TIGHTEN FIRST BRASS SET NUT AGAINST YOKE BOSS Figure 14. Cable Yoke Attachment HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 21...
. Figure 16. Engine Oil Dipstick (Removal) 1. Remove the gasoline cap located on top of fuel tank. PAGE 22 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Page 23
If this is the case there could be a blade pitch problem. Refer to the maintenance section of this manual for blade pitch adjustment procedure. Replace any worn blades. HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 23...
Serious damage to the machine or personal injury could be caused by Figure 22. Throttle (Idle Position) dropping a trowel. PAGE 24 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Page 25
9. To begin troweling, push the throttle lever (Figure 27) toward the " RUN " position. Figure 25. Starter Grip Figure 27. Throttle (Run Position) HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 25...
To pitch the blades upward using the " Standard " handle, (Figure 29) simply turn the star-wheel clockwise. Turning the star wheel counter clockwise will cause the blades to lay flat. Figure 29. Standard Handle PAGE 26 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Page 27
ALWAYS keep clear of rotating or moving parts while NEVER place your feet or hands inside the guard rings operating this equipment. while starting or operating this equipment. HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 27...
Figure 32. Finish Blade PAGE 28 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Page 29
This option is not available on electric trowel models. Figure 36. Lifting Bail HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 29...
Check and replace if necessary the arm bushings, thrust collar bushings and shaft seals. Check pitch control cables for wear. Figure 39. Correct Spider Plate Alignment PAGE 30 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Page 31
Replace the bushing if it is out of round THRUST or worn. COLLAR LOWER BUSHING WEAR PLATE CONE POINT SQUARE HEAD Figure 42. Bronze Bushings SET SCREW SPIDER PLATE Figure 40. Spider/Gearbox Removal HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 31...
Page 32
COUNTER CLOCK-WISE blade rotation use the fixture with the fixture arm in the DOWN position. (B in Figure 46). Figure 44. Trowel Arm Flatness Test PAGE 32 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Page 33
5. Loosen the locking nut on the trowel arm lever, then turn the trowel arm adjusting bolt until it barely touches (.010") the fixture adjusting bolt. HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 33...
Page 34
WARNING NEVER operate equipment with covers, or guards removed. Keep fingers , hands , hair and clothing away from all moving parts to prevent injury. PAGE 34 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Multiquip. Other entries will for sale through Multiquip. be clarified in the “Remarks” Column. PAGE 38 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
NOTES: APPLY LOCTITE P/N 1477 INCLUDED WITH ITEM 3 OR CAN BE ORDERED SEPARATELY( P/N 1471). SPIDER ASSEMBLY P/N 1215 INCLUDES ALL ITEMS WITHIN OUTLINE. PAGE 48 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Page 49
1215 SPIDER PLATE ASSY............1 ... INCLUDES ITEMS W/ % 1471 THRUST COLLAR BUSHING 10968 THRUST BEARING KIT ............ 1 ... INCLUDES ITEMS W/ HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 49...
HPHA36C5H TROWEL — GUARD RING ASSY. GUARD RING ASSY. PART NO. PART NAME QTY. REMARKS 20808 GUARD RING ASSEMBLY 1215 SPIDER PLATE ASSY. HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 57...
Page 73
HONDA GX160K1QX2 — CRANKSHAFT ASSY. CRANKSHAFT ASSY. PART NO. PART NAME QTY. REMARKS 13310ZE1622 CRANKSHAFT, Q- TYPE 501019 KEY, 3/16" x 45 MM HPHA36C5H WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #3 (07/06/10) — PAGE 73...
Need help?
Do you have a question about the HPHA36C5H and is the answer not in the manual?
Questions and answers