Settings; Parameter Descriptions; Displaying The Measured Values; Status And Sub-Status - REMEHA Gas 210 ECO PRO Service Manual

5

Settings

5.1

Parameter descriptions

Tab.13 Factory setting
Parameter Description
Minimum pump speed
Maximum pump speed
5.2

Displaying the measured values

Tab.14 Status and sub-status numbers
Status
Stand-by mode
Boiler start (heat demand)
Burner start
Burning on CH operation
7638135 - v.02 - 13082015
Adjustment 210-80
range
0% – 100%
0% – 100%
The control unit continually registers various values from the boiler and the
connected sensors. These values can be read on the control panel of the
boiler.

5.2.1 Status and sub-status

The information menu
bers:
Sub-status
Stand-by mode
Anti-swing
Open hydraulic valve
Start pump
Wait for the correct temperature before burner start
Open external gas valve
Fan on
Open flue damper
Pre-ventilation
Wait for release signal
Burner on
Gas leakage control VPS
Pre-ignition
Main ignition
Flame detection
Intermediate ventilation
Burner on (flue gas discharge test)
Temperature control
Limited temperature control (ΔT protection)
Capacity control
Temperature gradient protection level 1 (modulate down)
Temperature gradient protection level 2 (part load)
Temperature gradient protection level 3 (blocking)
Modulate up for flame control
Temperature stabilisation time
Cold start
210-120
20 20
100 100
gives the following status and sub-status num­
5 Settings
210-160 210-200
20 20
100 100
15