TechniSat TechniStar S2 Quick Start Manual page 42

Error
Receiver cannot be
operated, switched on or
switched off.
USB device not recognised.
Possible cause
Defective data stream -->
receiver blocked.
USB device formatted for
wrong file system.
42
Solution
Hold down the On/Stand-by
button on the receiver or
on the remote control for
approx. 5 seconds.
Disconnect mains plug for
approx. 5 seconds, then
reconnect receiver.
Perform Flash Reset:
Warning!
All personal settings will be
lost.
> Remove DC plug from
receiver.
> Press and hold the
Standby and up arrow
key at the same time.
> Reinsert DC plug in the
DC socket while holding
down the Standby and
up arrow buttons.
> Keep both buttons
pressed down for
approx. 5 sec. then
release. "SEt" appears
in the display.
Format USB device for
FAT32 file format.