Changing A Setting - TechniSat TechniStar S2 Quick Start Manual

Alternatively:
> Press the Menu button to leave the menu directly.
The settings that need to be saved manually will be reset in this case.
If the green function key with Accept is not displayed in the bottom line of the
screen, the changes are saved automatically on exiting the menu.

6.4 Changing a setting

You can create settings using the arrow selection method, via the selection list,
by entering numbers and by using the virtual keyboard. The receiver specifies
the method that can be used to change a highlighted setting. You can see this from the
following displayed symbols:
- Arrow selection method (Section 6.4.1)
Arrows are shown on the left or right edge of the highlight.
- Selection list (Section 6.4.2)
The symbol is shown on the right edge of the highlight.
- Entering numbers (Section 6.4.3)
- Virtual keyboard (Section 6.4.4)
The symbol is shown on the right edge of the high light.
6.4.1 Arrow selection method
> If is shown on the left and
the left/right arrow keys.
6.4.2 Selection list
If is shown on the right next to the set value, the value is changed using the selection list.
> Press the OK button to open the selection list.
> Highlight the setting you want using the up/down arrow keys.
By pressing the up/down arrow keys it is possible to move the highlight upwards/
downwards from line to line and sideways using the right/left arrow keys buttons.
on the right next to the set value, you can alter this using
19