Basic Operation; Switching The Receiver On/Off - TechniSat TechniStar S2 Quick Start Manual

6 Basic operation

Dear Customer
The following section starts by covering basic operation as well as recurring operating
steps for the TV. This should make it easier to read the instruction manual, since it avoids
repeated description of identical steps at each individual stage.
If a function or setting for the device has to be different from the basic operation, the
difference in operation is described in detail at the relevant point in the instruction manual.
The so-called "On Screen Display" is used on your TV. This simplifies operation of the
television since the buttons on the remote control can take on different functions, which
makes it possible to reduce the number of buttons.
In this On Screen Display (OSD for short) the selected functions or settings are highlighted.
Furthermore, you will see a line at the bottom edge of the screen in which the various
buttons on the remote control are shown with their current functions.
In this instruction manual the terms shown in the OSD as well as the buttons to be
pressed are highlighted from the rest of the text by the display format used.
Warning - indicates an important note which you absolutely should observe in order to
avoid problems with the device, loss of data or unwanted operation.
Tip - indicates a note about the function described as well as other functions
associated with it and any others to be observed with reference to the respective place
in the instruction manual.

6.1 Switching the receiver on/off

> When the receiver is on standby, you can switch it on by pressing the On/Standby
button on the remote control/TV set.
> When operating normally you can switch the receiver to standby mode by pressing the
On/Standby button.
When switching the receiver on and off, note section 7.3 as well.
6.2 Calling up the main menu and navigating through the menus /
functions
The following example will illustrate how you reach the main menu and call up a submenu.
The objective of the example is to call up the Picture settings menu.
> Press the Menu button. The main menu appears on the screen.
16