Fitting Instructions; Fully Lined Chimney - Stanley Cara+ Installation And Operating Instructions Manual

ALL FLUE INSTALLATIONS ARE THE
RESPONSIBILITY OF THE CUSTOMER.
The stove must be conencted from the flue spigot to
the chimney/ flue with a suitable flue connection that
provides an air tight seal. There is no requirement
to seal between the stove and the hearth or between
the stove and the fireplace. The boiler can be insu-
lated externally with fireproof rockwool insulation,
backfilling with vermiculite is not recommended as it
may affect the operation of the air controls.
Fig.3
Fig.4
5" - 8"
Adaptor/
Closure Plate
5

FITTING INSTRUCTIONS

Step 1
Prepare the fireplace area. Ensure the opening is
suitable for fitting of the insert stove opening
required, i.e. remove fire surround trim if fitted. See
Fig.5.
Fig.5
405mm - 455mm
Step 2
Ensure the floor area is level with the hearth, this
area needs to be level as the insert fire is screw
fixed to the floor.
Step 3
Decide which boiler tappings are to be used to con-
nect the boiler. Remove the temporary plugs from
the other two connections and replace with perma-
nent boiler plugs.
Step 4
Remove all internal parts as per pre-assembly
instructions prior to lifting it.
Step 5
Inset the stove to its final position.
USING CLOSURE PLATE - (Skip to Step 10)
Step 6
Drop the 150mm twin wall flexi flue liner down
through the chimney and into the stove.
Step 7
Lay the sealing gasket on to the flue spigot, connect
the flue spigot to the flexi pipe using a 5" extension
pipe and a 5" - 6" adaptor. It is not recommended to
fit a flexi flue liner within 600mm of the stove flue
spigot.
Step 8
Pull the flexi liner back up through the flue outlet and
fix the flue spigot into position using the M8 bolts
provided. It may be necessary to cut a prop to hold
the spigot in place while the fixings are being
attached.
240mm - 320mm
Min 380mm