Adjusting The Blower Speed; Normal Operating Sounds - FireplaceXtrordinair 36 DV XL Owner's Manual

Adjusting the Blower Speed

The internal blower helps transfer
the heat from the fireplace into the
room. It will not turn on until the
fireplace is up to temperature
(approximately 10 minutes after
starting). See the illustration below
for instructions on adjusting the
blower speed.
Optional Power Heat Duct
Allow the fireplace to reach normal operating temperature. Then use the wall-mounted rheostat to
operate the blower speed. The blower will automatically shut off after the fireplace cools.
OFF
Turn the dial all
the way counter-
clockwise until it
clicks off.

Normal Operating Sounds

Travis Industries
Operation
LO
BLOWER
CONTROL
HIGH
The high position is
all the way counter-
clockwise, without
clicking off.
Pilot Flame
The pilot flame,
which remains on,
makes a very slight
"whisper" sound.
Gas Control Valve
As the gas control
valve is turned on
and off you will hear
a dull clicking
sound. This is the
valve opening up
and shutting down.
9 3 5 0 8 1 0 3
Blower Knob
OFF
HI
Turn the knob all the way counter-clockwise to turn
the blower off. One click clockwise turns the
blower to high speed. Turning the knob clockwise
from the high position decreases the speed of the
blower.
Blower
This heater uses a high tech blower to push
heated air into the room. It will make a
whirring sound and will increase in volume as
the speed is increased.
Burner Pan
The burner pan is
underneath the logs and
is used to distribute the
gas to produce a clean,
aesthetic and efficient
burn. When the main
burner is getting up to
temperature you will hear
a creaking sound of the
thick metal expandingÐ
this sound will cease
once the fireplace is up
to temperature.
Blower Snap Disk
This part can
produce a clicking
sound as it turns the
blower on and off.
LOW
Turn the dial
all the way
clockwise.
1 5 1 0 0 2
3 3