Bypass Copying - Toshiba E-studio 200L User Manual

Bypass Copying

When you want to make copies on thick paper, OHP film, tracing paper, sticker labels or other
special sheet, use the sheet bypass. If the desired size of paper (standard size) is not set in the
drawers, or if you want to make copies on nonstandard size paper, make bypass copies.
The modes below are available even in bypass copying if the paper size is specified:
- Dual-page
- Duplex copying
- Image shift
- Edge erase
In these cases, the setting procedures of the following 2 sizes of paper are different:
- Bypass copying on standard size paper
- Bypass copying on non-standard size paper
When copying is finished, the lamp of the FUNCTION CLEAR button lights. The bypass
copying mode automatically returns to the default mode by pressing the FUNCTION
CLEAR button or after a while the automatic function clear mode works and the settings
will be cleared.
The copier stops its operation when the paper set on the bypass tray has run out even if there
is the same size of copy paper in the drawer. The copier starts again when adding the paper
on the bypass tray.
Page 19