Toshiba E-studio 200L User Manual page 22

Bypass Copying (Cont'd.)
Bypass Copying on Standard Size Paper
1. Place paper on the bypass tray, and then align the guides
with the size of the paper.
When adjusting the width of the side guide, while
holding down the knob of the side guide, slide the
side guide. "Ready for bypass feeding" appears.
Place the paper with the side to be copied facing down.
If you put several sheets on the bypass tray at a time,
fan the paper well before placing it.
Place the paper so as not to exceed the line indicated
on the guides.
Do not push the paper forcibly into the entrance of
bypass feeding. It may cause a paper jam.
TIPS:
Draw the triple paper holder depending on the
paper size.
Raise (B) before placing LD/A3 size or larger.
2. Place the original(s).
3. Press the button that represents the size of the paper that
has been set for LD, LG, LT and ST-R.
TIP: When the paper size is not specified, the copying
speed may be lower due to the cleaning operation inside
the copier.
Page 20