Ignition Wire; Park Lights - Mongoose MX40 II Series Operating & Installation Instructions Manual

IGNITION WIRE (+)

It is imperative that the ignition wire is connected to receive 12v when in the engine run and the crank
position of the ignition switch. The ignition input is also a back-up power supply to the main power
supply. Ensure this connection is secure.

PARK LIGHTS (+)

The MX40II is designed to f lash the parking lights, not the indicators. This wire is fuse protected to
prev ent shorting. Connecting to the indicators may overload the circuit and voids warranty.
DOOR TRIGGER – (Change jumper J5 for '+' or '-' input - factory set to (-) negative)
Connect this wire to a common door switch so that it receiv es a ground signal regardless of which door
is opened. Any other triggers may be connected at this point (bonnet, boot, shock sensor). In this
conf iguration, and when the optional siren is installed, a ground signal will cause the siren to sound.
GROUND WHEN ARMED (-)
This wires provides a ground signal when the system is armed. This may be used for a third
immobiliser relay.
CENTRAL LOCKING (-) LOCK / UNLOCK (Jumper J4 controls timing)
The MX40II has low current lock and unlock central locking outputs. Additional components may be
required depending on the ty pe of v ehicle and/or its' central locking. Please refer to the Mongoose
installation manual f or f urther details.
(Factory set at 0.3 sec pulse. Remove jumper J4 for 4.0 second pulse)