Pc Cards - Panasonic CF-M34 series Reference Manual

PC Cards

Label-side up
Button
Your computer has one PC Card slot. This slot conforms to the PC Card Standard;
therefore, communications and SCSI devices may be utilized. The slot allows you to
use one Type I or Type II card.
CAUTION
Check the PC Cards' specifications. Be sure the total operating current does
not exceed the specified limit. Damage may result otherwise.
Allowable Current : 3.3 V: 400 mA, 5 V: 400 mA
ZV, SRAM and FLASH ROM (except for an ATA interface) cards are not sup-
ported.
For the following cases, be sure the power has been turned off before pro-
ceeding.
• When removing a network card
• When replacing a CardBus type card with another card (including another
CardBus type card)
Installing/Removing the PC Card
Installing a PC Card
Open the cover
Simply slide the PC Card in until it snaps into place. Refer to the
manual for each card on how to install the card (insertion is typically
label-side up).
CAUTION
When inserting a card, do not force the card in if difficulty is encoun-
tered. You may damage the slot, making it impossible to remove the
card.
Removing a PC Card
CAUTION
Do not remove a PC Card while your computer is in the suspend or
hibernation mode.
Double-click
(When removing a PC Card after turning off the computer, this step
is not need.)
Press the button out, and then press the button again.
Slide the PC Card out.
on the task tray and press [Stop].
24