Suspend/Hibernation Functions - Panasonic CF-M34 series Reference Manual

Suspend/Hibernation Functions

Starting Up Your Computer Quickly
If you want to immediately start up and continue an application after shutting down
your computer, you can do so by using the suspend or hibernation function.
NOTE
With Windows 2000, the "Suspend" is called "Standby".
Differences between the suspend and hibernation functions
Function Suspend function
Where data is saved to Memory
Speed Fast
Requires power supply Yes
Setting the Suspend or Hibernation Function
1
Select [Start] - [Settings] - [Control Panel] - [Power Options],
in [Hibernate] add the check mark for [Enable hibernate sup-
port] and press [Apply].
2
In [Advanced], select [Standby] or [Hibernate] for [When I
press the power button on my computer] and press [OK].
NOTE
The operation of the computer when the LCD is closed can also be set in
[Advanced].
Shutting Down Using the Suspend or Hibernation Function
The computer should be set for suspend or hibernation (
dure).
Slide the power switch
(After releasing your finger from the power switch,
do not touch the power switch, keyboard or
mouse while the computer is entering in the sus-
pend or hibernation modes.)
CAUTION
At the "beep*" sound, release your finger from the power switch. If you con-
tinue to slide on the switch and hold it for more than four seconds, the "beep*"
sound will come out again and the power will go off. Data not previously
saved will be lost.
Even when [When I press the power button on my computer] is set to [Power
Off] with [Control Panel] - [Power Options], if the power switch is slid, a beep
will sound and the power will go off if the switch is slid for more than four
seconds, although the computer will not completely shut down.
If the computer will not be operated for an extended period of time, it is recom-
mended that hibernation mode is used instead of suspend mode.
* When the speaker function is disabled, e.g., by setting [Disable] for [Speaker] with the Setup
Utility ( page
(if power is cut, all data is lost)
Fn + F4 ,
35) or by the key combination
Hibernation function
Hard disk
Somewhat slow
Power not required to maintain data
see the above proce-
Suspend Mode
or
Hibernation Mode
there will be no beep sound.
12