Configuring The Touchscreen - Panasonic CF-M34 series Reference Manual

Touchscreen

Configuring the Touchscreen

Devices
Configure the device controller.
Hardware
Set the hardware resources.
Match this setting with the
setting for [Touch Screen] in
the Setup Utility.
Settings
Set the general protocol
settings.
When needed, the touchscreen can be configured using the following steps.
1
Select from the taskbar or select [Settings] from [Start] -
[Programs] - [Updd]
The following screen will appear.
Windows
Set the "double-click"
settings.
Advanced
Set the advanced settings.
2
Make necessary changes
3
Click [OK]
NOTE
Adjustments can be made when double-click operations are assumed by the
computer although single-click operations are intended, by clicking [Windows]
from the display shown above and decreasing the value for [Time] in [Double
Click Settings].
Immediately run [Calibrate] when the number of points of calibration is changed.
It is also possible to change the double click speed for [Tap and Buttons] in
[Start] - [Settings] - [Control Panel] - [Mouse]. It is important to note that when
the double click speed for [Mouse] is changed, the double click time for [Win-
dows] is also changed. However, the double click time for [Windows] and
[Mouse] returns to its value before the change when the computer is restarted.
Calibration
Define the calibration setup.
Use when the cursor can not be pointed correctly with
your finger. (Needed if the alignment of the touchscreen
with the visual image change or adjust the display reso-
lution).
Status
Display the status of the controller.
About
Display the version number.
Button Modes
Set the button modes.
General
Set the general settings and func-
tions.
Events
Set the events that can be generated
by a controller.
NOTE
For more information, refer to [Help].
11