Connecting The Speaker Cables; Connecting The Subwoofer - Denon AVR-X4100W Owner's Manual

Contents Connections
o Connecting the speaker cables
Carefully check the left (L) and right (R) channels and + (red) and –
(black) polarities on the speakers being connected to this unit, and be
sure to connect the channels and polarities correctly.
1
Peel off about 3/8 inch (10 mm) of sheathing from the
tip of the speaker cable, then either twist the core wire
tightly or terminate it.
2
Turn the speaker terminal counterclockwise to loosen it.
.
3
Insert the speaker cable's core wire to the hilt into the
speaker terminal.
4
Turn the speaker terminal clockwise to tighten it.
Front panel Display
Playback
.
.
.
Rear panel
Settings
o Connecting the subwoofer
Use a subwoofer cable to connect the subwoofer. Two subwoofers can
be connected to this unit.
To use two subwoofers, set "Subwoofer" to "2 spkrs" in the "Speaker
Config." setting. (v p. 226)
The level and distance can be set separately for Subwoofer 1 and
Subwoofer 2.
FRONT FRONT CENTER
SW1
.
41 Remote
Tips Appendix
HEIGHT1
SURROUND SURROUND SURROUND BACK SURROUND BACK
SW2
Index
HEIGHT1