Denon AVR-X4100W Owner's Manual page 237

Contents Connections
Network
To use this unit by connecting it to a home network (LAN), you must configure network settings.
If you set up your home network (LAN) via DHCP, set "DHCP" to "On". (Use the default setting.) This allows this unit to use your home network (LAN).
When assigning an IP address to each device manually, you need to assign an IP address to this unit using the "IP Address" settings, and enter
information about your home network (LAN) such as the gateway address and subnet mask, etc.
Information
Display network information.
Friendly Name / Connection / SSID / DHCP / IP Address / MAC
Address
MAC Address is required to create a vTuner account.
Connection
Choose whether to connect the home network to a wireless LAN or a
wired LAN.
When connecting to the network using wired LAN, select "Wired
(Ethernet)" after connecting a LAN cable,
When connecting to the network using wireless LAN, select "Wireless (Wi-
Fi)" and configure the "Wi-Fi Setup".
Front panel Display
Playback Settings
o Connect Using
Select the method for connecting to the home network (LAN).
Wired (Ethernet): Use a LAN cable to connect to a network.
Wireless (Wi-Fi):
You can disable the Wi-Fi function of this unit by configuring the following
settings.
1. Press and hold the main unit's o and p at the same time for at least 3
2. Use the main unit's i to display "zWired LAN <Unlock>".
3. Use the main unit's o or p to select "<Lock>".
4. Press the main unit's ENTER to complete the setting.
Rear panel 237
Tips
Use the wireless LAN (Wi-Fi) function to connect
to a network.
seconds.
"zVideo Format <NTSC>" appears on the display.
Remote Index
Appendix