Wall/corner electric fireplace and media mantel (49 pages)
Summary of Contents for Style selections 88317/23MM5661-Z402
Page 1
Style Selections is a registered trademark ® of LF, LLC. All rights reserved. MODEL #88317/23MM5661-Z402 Français p. 22 Español p. 43 Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-877-888-8225, 8 a.m. - 8 p.m., EST, Monday - Friday.
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock and injury to persons, including the following: DANGER: •...
Page 4
4. The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. SAFETY INFORMATION 5. Always unplug this appliance when not in use. 6.
SAFETY INFORMATION • Batteries are to be inserted with the correct polarity. • Exhausted batteries are to be removed from the product. • Non-rechargeable batteries are not to be recharged. SAVE THESE INSTRUCTIONS Cold-climate installation: It is mandatory the outer walls be insulated to conform to applicable insulation codes.
PACKAGE CONTENTS PART DESCRIPTION QUANTITY Base Center Left Side Panel Center Right Side Panel Center Front Panel Left Side Panel Right Side Panel Mantel Top Wood Shelf Left Front Panel Rigt Front Panel Center Shelf Left Door Right Door Support Panel Side Back Panel Upper Back Panel Securing Block...
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble, install or operate the product. To protect the product from possible scratches, please assemble the parts on a scratch-free surface.
Page 9
4. Insert plastic block from 2-block connector pack (V) where shown into center front panel (D). Secure with bolt (FF). Hardware Used Bolt 5. Insert wood dowels (AA) into each end of center front panel (D), then attach center front panel (D) to center left side panel (B) and center right side panel (C).
Page 10
7. Attach assembly from Step 5 to center shelf (K) using bolts (FF). NOTE: With the help of another person, flip cabinet on its side as shown for easy assembly. Hardware Used Bolt 8. Insert plastic blocks from 2-block connector pack (V) where shown into left side panel (E) and right side panel (F).
Page 11
10. Attach left side panel (E) and right side panel (F) to center shelf (K) where shown using bolts (FF). Hardware Used Bolt 11. Insert plastic blocks from 2-block connector pack (V) where shown into support panel (N). Secure with bolt (FF). Hardware Used Bolt 12.
Page 12
13. Attach base (A) to assembly using bolts (FF). Hardware Used Bolt 14. Attach the support foot (R) to base (A) by screwing it clockwise. Once secure, carefully flip assembly upright. 15. Attach the mantel top (G) to the assembly where shown using bolts (FF).
Page 13
16. Attach the upper back panel (P) and side back panels (O) to the back of the assembly using truss head screws (BB). Hardware Used x 43 Truss Head Screw 17. Use screws (EE) to attach hinges from hinge pack (Y) to left door (L) and right door (M).
Page 14
19. Align the hinges on left door (L) and right door (M) with the hinge brackets on the assembly, sliding the hinge until it is secure in the hinge bracket. Secure using screw preassembled on hinge brackets. To adjust the doors forward or backward, change keyhole slot position as in (a).
Page 15
WARNING: Be sure to read all safety information prior to installing the insert (S). Insert (S) should be installed in the mantel as close to the final position as possible; two people are recommended for this step. 22. Lift insert (S) carefully into the back of the unit and center in the insert opening.
Page 16
24. WARNING: Installing the tipping restraint hardware will help prevent accidents and/or damage to the unit. It is highly recommended you complete this step. Unit Anchor To secure the item to the wall, find and mark a stud wall closest to the edge of the left side of the mantel. Attach the wall anchor from the tipping restraint hardware pack (Z) at the marked locations using 2 of the screws from the pack.
OPERATING INSTRUCTIONS The heater can be operated by either the remote control or the control panel. Control Panel Display Front View of Insert (S) Remote (T) FUNCTION ICON DESCRIPTION POWER Use the POWER button to turn on or off the fireplace from the remote or control panel.
CARE AND MAINTENANCE • Dust the fireplace regularly with a soft, non-lint producing cloth or household dusting product. • Clean the fireplace with a gentle non-abrasive household cleaner. Make sure to dry the fireplace immediately with a soft cloth or towel. •...
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Unplug the fireplace, remove the back panel of the fireplace and The thermostat sensor is check that the thermostat is plugged into the main circuit board. If Display shows “ ”. broken or disconnected. this does not solve the problem, contact customer service for a replacement thermostat sensor.
1-YEAR LIMITED WARRANTY The manufacturer warrants this product to be free from manufacturing and material defects for a period of one year from date of purchase, subject to the following conditions and limitations. 1. Install and operate this item in accordance with the installation and operating instructions furnished with the product at all times.
Y15-C70-P85 Emberbed with Log Y15-S148-P02 Emberbed Circuit Board Y15-C75-P44E Blue Flame Circuit Board Y15-C70-P40BL Flame Circuit Board Y15-C76-P40 Spinner Y15-S148-P11 Remote Control P115 Printed in China Style Selections is a registered trademark ® of LF, LLC. All rights reserved. Lowes.com...