Wall/corner electric fireplace and media mantel (49 pages)
Summary of Contents for Style selections 88324/32MM40000-Z455
Page 1
Style Selections is a registered trademark ® of LF, LLC. All rights reserved. MODEL #88324/32MM40000-Z455 Français p. 23 Español p. 45 Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-877-888-8225, 8 a.m. - 8 p.m., EST, Monday - Friday.
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock and injury to persons, including the following: DANGER: •...
Page 4
4. The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. SAFETY INFORMATION 5. Always unplug this appliance when not in use. 6.
SAFETY INFORMATION • Batteries are to be inserted with the correct polarity. • Exhausted batteries are to be removed from the product. • Non-rechargeable batteries are not to be recharged. SAVE THESE INSTRUCTIONS Cold-climate installation: It is mandatory the outer walls be insulated to conform to applicable insulation codes.
PACKAGE CONTENTS PART DESCRIPTION QUANTITY Base Center Left Side Panel Center Right Side Panel Center Front Panel Left Side Panel Right Side Panel Mantel Top Center Shelf Center Left Upper Side Panel Center Right Upper Side Panel Inner Front Panel Left Upper Side Panel Right Upper Side Panel Center Back Panel...
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble, install or operate the product. To protect the product from possible scratches, please assemble the parts on a scratch-free surface.
Page 9
4. Slide preassembled connection plates on center front panel (D) and lower front panel (Y) to align with corresponding holes on center left side panel (B) and center right side panel (C). Secure using truss head screws (DD). Hardware Used Truss Head Screw 5.
Page 10
7. Attach left side pane (E) and right side panel (G) to base (A) using bolts (HH). Hardware Used Bolt 8. Attach center shelf (H) to assembly from underneath using bolts (HH). Hardware Used Bolt 9. Insert plastic blocks from connector pack (AC) where shown into center left upper side panel (I) and center right upper side panel (J).
Page 11
10. Attach center left upper side panel (I) and center right upper side panel (J) to the top of center shelf (H), securing with bolts (HH). Hardware Used Bolt 11. Attach the inner front panel (K) between center left upper side panel (I) and center right upper side panel (J) using long bolts (AA) and washers (BB).
Page 12
13. Insert plastic blocks from connector pack (AC) where shown into mantel top (G). Secure with bolts (HH). Hardware Used Bolt 14. Attach the mantel top (G) to the assembly from underneath using bolts (HH). NOTE: A short-handled screwdriver (not included) might be helpful.
Page 13
16. Attach the center back panel (N) and rear panels (O) where shown on the back of the assembly using truss head screws (DD). Hardware Used x 50 Truss Head Screw 17. Attach hinges from hinge pack (AB) where shown to left door (P) and right door (Q) using screws (GG).
Page 14
19. Align the hinges on left door (P) and right door (Q) with the hinge brackets on the assembly, sliding the hinge until it is secure in the hinge bracket. To adjust the doors forward or backward, change keyhole slot position as in (a). To adjust the doors right or left, loosen/tighten screw (b).
Page 15
22. Gently insert drawers into the drawer slides preassembled to assembly. Open the left drawer (S) and right drawer (T) to check if both slides are properly attached to the drawer. 23. Remove the preassembled bolt from the remaining 2 door pulls (FF), then attach the door pulls (GG) to the upper front panel (U) with the bolts.
Page 16
25. Attach insert support panels (V) where shown to base (A) using bolts (HH). Hardware Used Bolt WARNING: Be sure to read all safety information prior to installing the insert (W). Insert (W) should be installed in the fireplace as close to the final position as possible; two people are recommended for this step.
Page 17
27. Assembly is now complete. With the help of another person, move the unit to its final location and use the preassembled levelers as needed to ensure the unit’s stability. 28. WARNING: Installing the tipping restraint hardware will help prevent accidents and/or damage to the unit.
OPERATING INSTRUCTIONS The heater can be operated by either the remote control or the control panel. Control Panel Display Front View of Insert (R) Remote (X) FUNCTION ICON DESCRIPTION POWER Use the POWER button to turn on or off the fireplace from the remote or control panel.
CARE AND MAINTENANCE • Dust the fireplace regularly with a soft, non-lint producing cloth or household dusting product. • Clean the fireplace with a gentle non-abrasive household cleaner. Make sure to dry the fireplace immediately with a soft cloth or towel. •...
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Unplug the fireplace, remove the back panel of the fireplace and The thermostat sensor is check that the thermostat is plugged into the main circuit board. If Display shows “ ”. broken or disconnected. this does not solve the problem, contact customer service for a replacement thermostat sensor.
1-YEAR LIMITED WARRANTY The manufacturer warrants this product to be free from manufacturing and material defects for a period of one year from date of purchase, subject to the following conditions and limitations. 1. Install and operate this item in accordance with the installation and operating instructions furnished with the product at all times.
Emberbed with Log Y15-S148-P02 Emberbed Circuit Board Y15-C75-P44E Blue Flame Circuit Board Y15-C70-P40BL Flame Circuit Board Y15-C76-P40 Flame Generator/Spinner Y15-S148-P11 Insert Remote Control P115 Printed in China Style Selections is a registered trademark ® of LF, LLC. All rights reserved. Lowes.com...