Circuit Breakers; General Maintenance; Maintenance After Use - Nilfisk-Advance SC6500 40C Service Manual

Service Manual – SC6500
™

Circuit Breakers

The machine circuit breakers are located on the panel to
the left of the Operator seat.

General Maintenance

Maintenance After Use

1. When finished scrubbing, press the Scrub Off Switch. This will automatically raise the scrub deck and
squeegee, and switch off the solution, detergent and vacuum systems.
2. Drive the machine to a service area for daily maintenance, and check the machine for any additional
maintenance or service that may be needed.
3. To empty and clean the solution tank:
a. Remove the
Solution Tank Drain
from its storage clamp.
Hose
b. Direct the
Solution Tank Drain Hose
to a designated disposal site and
remove the
Solution Tank Drain
.
Hose Plug
c. Rinse the tank with clean water.
4. To empty and clean the recovery tank:
a. Pull the
Recovery Tank Drain Hose
from its storage area.
b. Direct the
Recovery Tank Drain
to a designated disposal site
Hose
and remove the
Recovery Tank
. (Hold the end of
Drain Hose Plug
the
Recovery Tank Drain Hose
the water level in the tank to avoid
sudden, uncontrolled wastewater
flow.) The
Recovery Tank Drain Hose
can be squeezed to regulate the
flow.
c. Rinse the recovery tank with clean
water.
above
Recovery Tank
Drain Hose
Hopper
Solution Tank
Solution Tank
Drain Hose
Drain Hose Plug
General Information
Recovery Tank
Drain Hose Plug
Vacuum
Hose
27