Nilfisk-Advance SC6500 Use & Maintenance

ATTENTION!
Do not use the machine before you have read and understood the User Manual
1. Check the battery charge gauge
(and if necessary re-charge)
6. Install squeegee
11. Install Brushes. 12. Adjust side skirts height
16. In case something does not work
enter the Service test mode by press-
ing the Speed switch and the trac-
tion control switch, then on the key.
Go through the menu.
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to
carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
Nilfisk-Advance A/S Tel.: +45 43 23 81 00
Sognevej 25 Fax: +45 43 43 77 00
DK-2605 Brøndby mail.com@nilfisk-advance.com
Denmark www.nilfisk.com
2. Check that the drive pedal is re- 3. Check battery cables are well con-
sponding and all circuit breakers are
armed
7. Check the height of the squeegee by 8. Open broom door compartment and
adjusting the castor wheels and the
angle knob.
13. Make sure that deck and squeegee
USE & MAINTENANCE
SC6500
4. Recovery tank seal cover must
nected together correctly installed and in good
condition
9. Check presence of water in the
check presence of ropes or debris solution tank.
that can block it.
14. Adjust water flow.
are moving down when pressing
the button.
5. Inspect the squeegee blades for cuts
or chunks
10. If necessary open the solution filter
cage and clean the net.
15. Adjust detergent flow.