wsm RTV900 Workshop Manual page 43

RTV900, WSM
Replacing Transmission Oil Filter
CAUTION
• Be sure to stop the engine before changing the oil filter
cartridge.
• Allow engine too cool down sufficiently, oil can be hot and
can burn.
1. Remove the drain plug (4) at the bottom of the transmission case
and drain the oil completely into the oil pan.
2. Clean off metal fillings with clean rags at the drain plug with
magnet (4).
3. After draining reinstall the drain plug (4).
Tightening torque Drain plug with magnet
4. Remove the rear guard.
5. Remove the oil filters.
6. Put a film of clean transmission oil on the rubber seal of the new
filter.
7. Quickly tighten the filter until it contacts the mounting surface,
then, with a filter wrench, tighten it an additional 1 turn only.
8. After the new filter has been replaced, fill the transmission oil up
to the upper notch on the dipstick (6).
9. After running the engine for a few minutes, stop the engine and
check the oil level again, add oil to the prescribed level.
10.Make sure that the transmission fluid does not leak past the seal
on the filters.
11.Install the rear guard.
IMPORTANT
• To prevent serious damage to the transmission, use only a
KUBOTA genuine filter.
(1) Transmission Oil Filter (HST)
(Yellow Color)
(2) Transmission Oil Filter
(Suction) (Orange Color)
(3) Rear Guard
(4) Drain Plug with Magnet
(5) Oil Inlet
(6) Dipstick
G-27
G GENERAL
58 to 67 N·m
5.9 to 6.9 kgf·m
43 to 49 lbf·ft
A : Oil level is acceptable within this
range.
W1059727
KiSC issued 03, 2008 A