Servicing Specifications - wsm RTV900 Workshop Manual

RTV900, WSM

2. SERVICING SPECIFICATIONS

Charge Relief Valve
Check and High Pressure Relief Valve
Servo Piston Operation Pressure (When
Neutral Adjusted)
Rear Wheel (Axle) Rotation at L Speed
Differential Case to Differential Side Gear
Differential Pinion Shaft to Differential
Pinion
Differential Pinion to Differential Side Gear
6T Spiral Bevel Pinion Shaft
Bevel Pinion Shaft to Bevel Gear
Item
Setting Pressure
Setting Pressure
–
Difference
Pressure (P1-P2)
At Rated Engine
Speed
Clearance
Differential Case
(I.D.)
Differential Side
Gear (O.D.)
Clearance
Differential Pinion
(I.D.)
Differential Pinion
Shaft (O.D.)
Backlash
Turning Torque
Backlash
2-S4
Factory Specification
0.52 to 0.72 MPa
2
5.3 to 7.3 kgf/cm
75 to 104 psi
25.5 to 26.5 MPa
2
260 to 270 kgf/cm
3698 to 3840 psi
(Operating Pressure)
22.6 to 26.5 MPa
2
230 to 270 kgf/cm
3271 to 3840 psi
+0.05 to +0.20 MPa
2
+0.5 to +2.0 kgf/cm
+7.1 to +28.4 psi
-1
126 to 141 min (rpm)
0.050 to 0.151 mm
0.0020 to 0.0059 in.
38.000 to 38.062 mm
1.4961 to 1.4985 in.
37.911 to 37.950 mm
1.4926 to 1.4941 in.
0.080 to 0.122 mm
0.0031 to 0.0048 in.
20.060 to 20.081 mm
0.7898 to 0.7906 in.
19.959 to 19.980 mm
0.7858 to 0.7866 in.
0.15 to 0.30 mm
0.0059 to 0.0118 in.
0.1 to 0.3 mm
0.0039 to 0.0118 in.
0.1 to 0.3 mm
0.0039 to 0.0118 in.
TRANSMISSION
Allowable Limit
–
–
–
–
–
0.30 mm
0.0118 in.
–
–
0.30 mm
0.0118 in.
–
–
0.40 mm
0.0157 in.
–
–
W1013874
KiSC issued 03, 2008 A