wsm RTV900 Workshop Manual page 368

RTV900, WSM
Rear End Frame
1. Unscrew the two nuts and two screws holding the drive end
frame and the rear end frame.
2. Remove the rear end frame (1).
(1) Rear End Frame
Rotor
1. Press out the rotor (1) from drive end frame (3).
IMPORTANT
• Take special care not to drop the rotor and damage the slip
ring or fan, etc..
(1) Rotor
(2) Block
Retainer Plate
1. Unscrew the four screws holding the retainer plate, and remove
the retainer plate (1).
(1) Retainer Plate
Bearing on Drive End Side
1. Press out the bearing from drive end frame (3) with a press and
jig (1).
(1) Jig
(2) Block
8-S28
ELECTRICAL SYSTEM
W1048215
(3) Drive End Frame
W1048368
W1048574
(3) Drive End Frame
W1048760
KiSC issued 03, 2008 A