wsm RTV900 Workshop Manual page 261

RTV900, WSM
Drive Shaft and Lower Arm
1. Remove the front case cover mounting screw (1).
2. Draw out the drive shaft assembly (4).
3. Remove the lower arm mounting bolt and nut (2).
4. Remove the lower arm (3).
(When reassembling)
• Take care not to damage the O-ring of front case cover.
NOTE
• Tighten the lower arm mounting bolt and nut (2) with the
specified torque after setting up the wheel and unloading the
machine on ground.
Front case cover mounting
screw
Tightening torque
Lower arm mounting bolt
and nut
(1) Front Case Cover Mounting Screw
(2) Lower Arm Mounting Screw and Nut
5-S8
FRONT AXLE
17.7 to 20.6 N·m
1.8 to 2.1 kgf·m
13.3 to 15.5 lbf·ft
102.9 to 117.6 N·m
10.5 to 12.0 kgf·m
75.9 to 86.7 lbf·ft
(3) Lower Arm
(4) Drive Shaft Assembly
W1018017
KiSC issued 03, 2008 A