Remote Control Instructions - Aircommand sandpiper Owner's Manual

Sandpiper Installation Guide

With " "blinking, Press "

Press " " for 3 seconds to change between On and Off timer setting

Press " " for 3 seconds to cancel On/Off timer set for current day

Press " " for 6 seconds to cancel all On/Off timer that previously set

System will save all settings and returns to main menu if there is no input for 10 seconds. Note: "
displayed when the weekly timer has been set.
BUTTON LOCK

This provides a means of locking the mode and fan settings to prevent any unintended input

Press " " and "

" " will display when button locked. Note: On/Off "
TEMPERATURE DISPLAY SETTING

Press " " and "

REMOTE CONTROL INSTRUCTIONS


The functions on the remote control are the same as on the LCD touchscreen except that the timer function can
only be set from the LCD touchscreen (see Figure 11 for diagram)

The functions operate the same way if set by the remote or the LCD touchscreen

The clock icon is used to set the time on the remote. Press once and then adjust the time using the up/down
arrows. Press the up/down arrow once to move ahead/behind by 1 minute, hold up/down arrow to move
ahead/behind by 10 minutes. Once your desired time is displayed press "SET" to save this time on the remote.

The light bulb icon will switch the backlight either on/off. To switch the backlight on/off hold the light bulb icon
for 3 seconds.
28
" or " " to change set time
" for 3 seconds to activate button lock, to unlock repeat the procedure
" for 5 seconds to change temperature measurement unit to either ℃ or ℉
th
May 2013 – Revision 7
" will not be affected by the button lock
Page 14 of 22
" will be