Aircommand sandpiper Owner's Manual page 13

Sandpiper Installation Guide
COOLING

Cycle mode button to highlight the snowflake icon "

You may select High, Med, Low or Auto fan speeds by pressing the fan button

Now select the desired room temperature (herein referred to as the "set point") by pressing the plus or minus
" " or "
keys
your desired set point. In approx. 5 seconds the display will resume reading the actual room temperature. The
compressor will have a delayed start usually 3 minutes before unit starts to cool.
Note: Any interruption to the power supply will cause the unit to delay compressor start up.
FAN ONLY

For simply recirculating air, choose the Fan mode
" "
button . Note: Temperature button is invalid in Fan only mode.
HEAT

Cycle mode button to highlight the sun icon "

Select desired set point temperature by pressing the plus or minus keys

After a short delay the compressor will start. However, air will not begin to flow until it has been heated up
sufficiently; this is to prevent cold draughts.
DRY

The Dry mode is used when the room temperature is close to comfortable but you wish to dehumidify the air.

Cycle mode button to highlight the snowflake/dripping icon "

Select desired set point temperature by pressing the plus or minus keys
locked in LOW.

The compressor will cycle on and off at approximate intervals of 6 minutes to extract moisture from the air.
AUTO

The Auto mode "

Press MODE until AUTO is displayed in the Mode Display

Press FAN SPEED until the required speed is selected

Select desired set point temperature by pressing the plus or minus keys

Press TEMPERATURE UP / DOWN for your required set point temperature.
SLEEP

With the unit operating in cool mode, press "
icon). The unit will automatically raise the set point by 1 ˚C per hour for the next three hours. Conversely in heat
mode, the set point will be lowered by 1˚C. Note: Sleep mode will automatically be cancelled in 8 hours.
TIMER (will work only when set on the LCD touchscreen, it will NOT work if set by the remote)

The timer function may be used to turn the unit either off or on at any point during the week. Note: ensure that
you have correctly set the time and day before attempting to set the timer.

Press " " and "

"--:--" will display if there is no setting

With " "blinking, press "
28
"
, the display will flash the set point temperature. Keep pressing the button until it flashes
" is used when Turn unit ON
" for 6 seconds to enter timer setting menu（"
" to change the day setting
th
May 2013 – Revision 7
".
" "
. Choose any of the three fan speeds by pressing the fan
".
".
" and " " for 3 seconds to highlight the sleep light (moon
" "
.
" " or " "
.
" " or " "
. Note: the fan speed is
" " or " "
.
"will display after two beeps)
Page 13 of 22