Nfc Module - HP elitebook 820 G2 Maintenance And Service Manual

Reverse this procedure to install the TouchPad.

NFC module

Description
NFC module
Before removing the NFC module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service cover (see
a. Battery (see
b. Hard drive (see
c. Keyboard (see
d. Top cover (see
Remove the NFC module:
1. Turn the top cover upside down with the front toward you.
2. Disconnect the bottom cable (1) and top cable (2) from the NFC module.
3. Remove the NFC module (3).
Reverse this procedure to install the NFC module.
Service cover on page
Battery on page 39)
Hard drive/solid-state drive on page
Keyboard on page 50)
Top cover on page 57)
37), and then remove the following components:
41)
Component replacement procedures
Spare part number
781862-001
69