Advertisement

Operating Instruction

for KONVEKTA air conditioning unit
KL60
Version:
 12 Volt DC
 2-circuit
 Recirculated Air / Fresh Air
 Heating
with control KS60/12V
ID#: BBA-KL60222AB
Version: A00
Konvekta AG
Am Nordbahnhof 5
34613 Schwalmstadt
Germany
+49 ( 0 ) 66 91 / 76
– 0
+49 ( 0 ) 66 91 / 76
– 200
Info@konvekta.com
www konvekta com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KL60 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for KONVEKTA KL60

  • Page 1: Operating Instruction

    Operating Instruction for KONVEKTA air conditioning unit KL60 Version:  12 Volt DC  2-circuit  Recirculated Air / Fresh Air  Heating with control KS60/12V Konvekta AG Am Nordbahnhof 5 34613 Schwalmstadt Germany  ID#: BBA-KL60222AB +49 ( 0 ) 66 91 / 76 –...
  • Page 2: Table Of Contents

    5.2. Condenser coil ........................11 5.3. Troubleshooting ......................... 12 Warranty Conditions ......................13 Adequate waste management ................... 13 History of modification ...................... 13 Append.:  Maintenance Schedule WP07050618  Wirung diagram no. BK1-70T-128  KONVEKTA Service Stations 307BBAKL60222AB.doc Edition: 16.09.2008 Page: 2/13...
  • Page 3: Introduction

    KONVEKTA will annul without prenotice all obligations concerning guarantee, service contracts etc. regardless if granted by KONVEKTA or its distributors in case other than original KONVEKTA spare parts or parts bought from KONVEKTA AG have been used for maintenance and repair.
  • Page 4: Notes To The Operating Instruction

    In case your product is equipped with details not shown or described in the operat- ing instruction, your KONVEKTA -Service-Station will always be at disposal for in- forming you about correct operation.
  • Page 5: Technical Data

    (conform the mixing ratio to manufacturers` instructions). This is abso- lutely necessary to prevent the heaters from frost damage! (The prevalent antifreeze filling of the vehicle manufacturers goes down to -40°C) Air conditioning unit 1.1. Type KL60 Refrigerant R134a - quantity approx. 22.1 [kg] [10]...
  • Page 6: Intended Use

    Intended use The KONVEKTA air conditioning unit is an air conditioning system that works with the ozone friendly refrigerant R 134a and which creates a pleasant and individually adjustable room tem- perature by means of forced convection. The determined use includes also the observance of the operating instructions as well as the proof of regular inspections.
  • Page 7: Operation With Control Ks60

    Operation with control KS60 General information 4.1. The air conditioning control KS60 is a control and regulation device for air conditioners in modern buses. The bus driver is relieved from all questions of an optimum air conditioning in the passen- gers’...
  • Page 8: Operation Panel / Function Of The Keys

    Operation panel / function of the keys 4.2. Control KS60/12V, Part no.: H11-005-401 Short. Function 3-figure display required room temperature can be adjusted (increase) 59 to 82.4°F required room temperature can be adjusted (decrease) 59 to 82.4°F required air volume can be adjusted (increase), step 1 or 2 -manually required air volume can be adjusted (decrease), step 1 or 2 -manually A/C automatic (A/C ON/OFF) Recirculated Air operation...
  • Page 9: Operation Of A/C System

    ATTENTION: In case of trouble in the a/c cooling circuit the LED-display (key S5 , see 5.3) is lighting up. Operation of the a/c system only after verification by qualified a KONVEKTA-Service-  Station ...
  • Page 10: Reheat Activate / Stop

    REHEAT activate / stop 4.7. Switching on of the air-conditioning system via button S5 afterwards the key S5 will be pressed shortly twice (double click). REHEAT will be activated for a period of 20 minutes, the LED-display will light up at the same time. ...
  • Page 11: Maintenance / Servicing

    All works or modifications at the air conditioner which are improperly executed can lead to function troubles and can jeopardize the operation safety. We recommend  having works and modifications only executed in a KONVEKTA service station so the prescribed regular maintenance works should be executed in an authorized ...
  • Page 12: Troubleshooting

    Loud noise  replace either bearing or entire com- at compres- defective bearing at compressor pressor   slack V-belt check V-belt at compressor drive  = see hand book„KONVEKTA Service Stations  = by user 307BBAKL60222AB.doc Edition: 16.09.2008 Page: 12/13...
  • Page 13: Warranty Conditions

    Warranty Conditions The current „General Warranty Conditions” KONVEKTA AG“ will apply. A copy will be furnished by the warranty department. Please contact gwl@konvekta.com Adequate waste management After the phase of use the last proprietor is responsible for the adequate waste manage- ment.

Table of Contents

Save PDF