Contents Page: Introduction ......................... 3 • Information on the operating instructions ................ 4 • Technical data air conditioning unit ................4 1.1. Compressors ........................5 Determined use ........................ 5 General information a/c unit ................... 5 Operation .......................... 6 4.1. Control unit ........................6 4.2.
These operating instructions contain all necessary information to operate your air conditioning unit. In case you need more explanations please contact the next KONVEKTA service station. On our website www.konvekta.com in category >service< you will find a survey of contact details of all our service partners close to your location.
In the course of further developments we reserve the right to technical modifications without preno- tice. Guarantee and liability conditions of KONVEKTA AG’s general business conditions are not enlarged by the above notes. Indications and photos should neither be copied and circulated nor used for competitor’s purposes.
If you think that the a/c unit is damaged, switch it off immediately. To avoid further damage have it check at a KONVEKTA Service Station . Only after that you can take unit into operation. BAKL40T12AF Edition: 20.03.2018...
3.1. Operating Conditions NOTE: KONVEKTA uses components made of copper and aluminium, which last a whole unit life- time under normal environmental conditions. Should the units be operated under aggressive envi- ronmental conditions, i.e. air containing salt-, phosphate- or ammoniac extremely, a corrosion of the cupper- and aluminium components can not be ruled out.
4.2. Flap for windshield/floor The flap for windshield respectively floor are controlled according to the symbolism. Arrow down: Flap for floor The whole air is lead to the floor Arrow down/up: Mid-position Air circulation is split up between floor and windshield. Arrow up Flap for windshield The whole air is lead to the windshield.
Before carrying out any maintenance works at your air conditioning unit, carefully read the KONVKETA safety provisions (TD00052A ) in order to avoid any dangers and accidents! On our website www.konvekta.com in category >service< you will find a survey of contact details of all our service partners close to your location.
V-belt − check V-belt at compressor drive On our website www.konvekta.com in category >service< you will find a survey of contact details of all our service partners close to your location. By user Warranty Conditions The current „General Warranty Conditions KONVEKTA AG“ will apply. A copy will be furnished by the warranty department.
Waste disposal in accordance with legal provisions After the phase of use the last proprietor is responsible for the adequate waste management. The environmental regulations in the exporting country must be observed. The following list contains the most important regulating literature, valid for the Federal Rep. of Germany: Resolution for dangerous substances Resolution for used oil...
Need help?
Do you have a question about the KL40T/24V and is the answer not in the manual?
Questions and answers