Control Panel Assembly; Removing The Control Panel - Dell DSS 1500 Owner's Manual

1. Ensure that you read the
2. Follow the procedure listed in
Steps
1. Use the hooks on the chassis as guides to align the hard drive backplane.
2. Slide down the hard-drive backplane until the release tabs snap into place.
3. Connect the SAS/SATA/SSD data, signal, and power cables to the backplane.
Next steps
1. Install the hard drives in their original locations.
2. Follow the procedure listed in
Related Tasks
Installing a hot-swappable hard drive carrier

Control panel assembly

Removing the control panel

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
3. Keep the #2 Phillips screwdriver handy.
Steps
1. Using a #2 Phillips screwdriver, remove the screw(s) securing the control panel to the chassis.
CAUTION: Do not use excessive force when removing the control panel as it can damage the
connectors.
2. Release the locking tabs of the control panel by angling up the control panel and away from the
system.
3. Remove all the cables connecting the control panel to the chassis.
88
Safety instructions.
Before working inside your
After working inside your
Safety instructions.
Before working inside your
system.
system.
system.