Dell DSS 1500 Owner's Manual page 71

support and follow the instructions included in the compressed download file to install the update
on your system.
4. If connected, disconnect the cables from expansion card(s).
5. If installed, remove the PCIe expansion card riser.
6. Remove the cooling shroud.
NOTE: If applicable, close the expansion card latch on the cooling shroud to release the full
length card.
7. Remove the heat sink.
8. Keep the Phillips #2 screwdriver ready.
Steps
1. Using a clean, lint-free cloth remove any thermal grease from the surface of the processor shield.
CAUTION: The processor is held in its socket under strong pressure. Be aware that the
release lever can spring up suddenly if not firmly grasped.
2. Position your thumb firmly over the socket-release lever 1 and lever 2 of the processor and release
both the levers simultaneously from the locked position by pushing down and out from under the
tab.
Figure 27. Processor shield opening and closing lever sequence
1. socket-release lever 1
3. socket-release lever 2
3. Hold the tab on the processor shield and rotate the shield upward and out of the way.
4. Lift the processor out of the socket and leave the release lever up so that the socket is ready for the
new processor.
2. processor
71