Remote Management Port Card (Optional); Removing The Remote Management Port Card - Dell DSS 1500 Owner's Manual

Remote management port card (optional)

The remote management port card is used for advanced management of the system.

Removing the remote management port card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
3. If applicable, disconnect the cables from expansion card(s).
4. Remove the expansion card riser.
NOTE: If applicable, close the expansion card latch on the cooling shroud to release the full
length card.
5. Remove the cooling shroud.
6. Keep the Phillips #2 screwdriver ready.
Steps
1. Disconnect the management network cable from the remote management port.
2. Loosen the two screws securing the remote management port card holder to the system board.
3. Pull the remote management port card up and toward the front of the system to disengage it from
the connector and remove the card from the chassis.
66
Safety instructions.
Before working inside your system.