Connecting To A Nonlinear Editing System (Av/C Connection); Connections For Cut Editing - Sony PDW-F30 Operating Instructions Manual

notebook computer, and use an appropriate i.LINK
cable.
See "Using PDZ-1 Proxy Browsing Software" in Chapter
4 (page 69) for more information about installing the
PDZ-1 software. See the online help of PDZ-1 for more
information about using PDZ-1.
Some limitations apply to FAM connections. For details,
see "File Operations in File Access Mode (for Windows)"
in Chapter 5 (page 73).
COMPOSITE OUT AUDIO MONITOR
R L
AUDIO OUTPUT
1/3 2/4
MONITOR
Laptop computer
On the computer
Install PDZ-1.
Connecting to a Nonlinear Editing
System (AV/C Connection)
You can send video/audio signals (AV/C data) from this
unit to a nonlinear editing system connected to the S400
connector.
The following figure shows an example connection.
See "Using PDZ-1 Over an i.LINK Connection (FAM
Connection)" (page 24) for the connections and settings to
make a FAM connection between this unit and a nonlinear
editing system.
Notes
• The S400 connector of this unit outputs video/audio
signals in DVCAM format. Data recorded in MPEG HD
format is output after being converted into DVCAM
format.
PDW-F30 (this unit)
-
AC IN
POWER
RS232C REMOTE(9P)
S400
S400
i.LINK cable
(not supplied)
i.LINK (IEEE1394) connector
On this unit
Set the setup menu item
INTERFACE SELECT >i.LINK
MODE to "FAM(PC REMOTE)"
(see page 89).
• The nonlinear editing system to be connected to this unit
requires editing software (not supplied) supporting the
DVCAM format.
• To transfer video and audio signals (AV/C data), use
AUDIO CONTROL >DV OUT MODE (see page 89) in
the setup menu to select the audio mode (the factory
default is "2ch").
• This unit's S400 connector has 6 pins. Check the
number of pins on the i.LINK connector of your laptop
computer, and use an appropriate i.LINK cable.
COMPOSITE OUT AUDIO MONITOR
R L
AUDIO OUTPUT
1/3 2/4
MONITOR
i.LINK (IEEE1394) connector
Laptop computer
On the computer
Install editing software
supporting the DVCAM
format.

Connections for Cut Editing

By connecting this unit to a VTR, you can configure a cut
editing system. Some example connections are shown in
the following.
When making the connections, also refer to the manuals
provided with the equipment to be connected.
When using the editing functions of the
recorder (connections using the S400
connector)
The following figure shows a cut editing system
comprising this unit as a player and a DSR-2000A/2000AP
unit as a recorder. In this system, video/audio signals and
PDW-F30 (this unit)
-
AC IN
POWER
RS232C REMOTE(9P)
S400
S400
i.LINK cable
(not supplied)
On this unit
Set the setup menu item
INTERFACE SELECT
>REMOTE I/F to "i.LINK" (see
page 89).
Set the setup menu item
INTERFACE SELECT >i.LINK
MODE to "AV/C" (see page
89).
Connections and Settings
25