Rear Panel - Sony PDW-F30 Operating Instructions Manual

you play back clips recorded with the Clip Continuous Rec function (see
page 40), you should set this menu item to "REC START EM".
d STOP/STANDBY button
This functions as a STOP button when pressed alone, and
as a STANDBY button when pressed together with the
SHIFT button.
STOP button: Press this button, turning it on, to stop
recording or playback. The frame at the stop position
is displayed.
STANDBY button: Press this button to put the unit into
standby-off mode (the STOP button lights, and the
STANDBY indicator off). Press it again to return to
the original state (the STOP button lights, and the
STANDBY indicator lights).

Rear Panel

1 Analog video signal
output section
2 Analog audio signal
output section
1 Analog video signal output section
1 COMPOSITE OUT connectors
COMPOSITE OUT
18
Names and Functions of Parts
COMPOSITE OUT AUDIO MONITOR
R
AUDIO OUTPUT
1/3 2/4
MONITOR
2 MONITOR
connector
MONITOR
This unit has a function that can put it into standby-off
mode automatically after a certain length of time passes in
disc stop mode. For details, see the explanation of STILL
TIMER in the setup menu (page 86).
e TS REC (transport stream record) button
Press this button together with the PLAY button to start
recording. Recording starts on the unrecorded part of the
disc.
Press the STOP button to stop recording. A clip is created
from the recorded section.
Note
This button is enabled when you record TS input signals
(when the PDBK-102 MPEG-TS Input/Output Board is
installed) or the signals of the internal signal generator.
- AC IN
L
RS232C REMOTE(9P)
a COMPOSITE OUT connectors (phono jack, BNC
type)
These output composite video signals.
When CHAR SEL on the HOME page of the function
menu is set to "ON" (see page 79), information such as
timecode, menu settings, and error messages is
superimposed on the output signals.
b MONITOR connector (D-sub 15-pin)
This outputs HD analog video signals. The output signals
can be switched with INTERFACE SELECT >D-SUB
OUTPUT in the setup menu (see page 89).
POWER
3 Power supply
section
S400
4 External device connection
section