Positive Stops - Steel City 35620 User Manual

Fig. 13
A
5. If they are not the same, loosen the four socket
head cap screws(A) that hold the table to the base.
Two are shown in FIG 13, the other two are on the
opposite side of the machine. SEE FIG 13.
6. Make the needed adjustments and tighten the four
hex socket cap screws firmly.
7. Check the alignment once again after tightening
hardware.
ADJUSTING 45° AND 90°

POSITIVE STOPS

The stops have been adjusted at the factory. After a
period of use, or, after moving the saw to another
location, the stops may no longer be set properly.
To check and adjust the stops:
WARNING
!
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
1. Raise the saw blade to its maximum height using
the handwheel.
2. Set the blade at 90 degrees to the table by turning
the blade tilting handwheel clockwise as far as it
will go.
3. Place a square on the table and check to see that
the blade is at a 90° angle to the table. Make sure
square is not touching a blade tooth. SEE FIG. 14.
Fig. 14
4. If blade is not at 90 degrees, open the motor cover
door, loosen lock nut (A) and turn adjusting stop
screw (B) on the front trunnion in, or out. The
adjusting stop screw should stop against the front
trunnion bracket when the blade is 90° to the table.
SEE FIG. 15.
Fig. 15
21
B
A