Sharp AR-M236 Service Manual page 87

Note: Executable only when the FAX is installed.
66-17
Purpose Operation check/test
Function Used to check the DTFM signal send operation.
(Purpose) (Signal send level: Max.)
Section FAX
Item Operation
Operation/procedure
Enter the DTFM signal (1 digit (1 to 9, 0, *, #)) and press the [START]
key.
When the [CUSTOM SETTINGS] key is pressed during execution, the
simulation is terminated.
Note: Executable only when the FAX is installed.
66-18
Purpose Operation check/test
Function Used to check the DTFM signal send operation.
(Purpose) (Signal send level: Set by soft SW.)
Section FAX
Item Operation
Operation/Procedure
Enter the DTFM signal (1 digit (1 to 9, 0, *, #)) and press the [START]
key.
When the [CUSTOM SETTINGS] key is pressed during execution, the
simulation is terminated.
Note: Executable only when the FAX is installed.
66-19
Purpose Back up
Function Used to write the SRAM data to the Flash ROM.
(Purpose)
Section FAX
Item Data
Operation/Procedure
Select "1: YES" with the 10-key, and press the [START] key. The data
are backed up. (When "2: NO" is selected, the simulation is canceled.)
* The AR-FX5 data cannot be written into the AR-FX7. If it is exe-
cuted, data are initialized and deleted. In addition, the AR-FX7 data
cannot be used in the AR-FX5.
Note: Executable only when the FAX is installed.
66-20
Purpose
Function
1
(Purpose)
Section
Item
Operation/Procedure
Select "1: YES" with the 10-key, and press the [START] key. The Flash
ROM data are read out and written into the SRAM. (When "2: NO" is
selected, the simulation is canceled.)
* The AR-FX5 data cannot be written into the AR-FX7. If it is exe-
cuted, data are initialized and deleted. In addition, the AR-FX7 data
cannot be used in the AR-FX5.
Note: Executable only when the FAX is installed.
66-21
Purpose
Function (Purpose)
Section
Item
Operation/procedure
1. Select the item to be printed.
2. Press the [START] key.
The information of the selected item is printed.
1
2
3
4
Note: Executable only when the FAX is installed.
66-22
Purpose
Function
(Purpose)
Section
Item
Operation/procedure
1. Select the set volume. (Max., Middle, Min.)
2. Press the [START] key.
Switch of 1, 2, and 3 can be made during execution of the simulation.
During execution of the simulation, sounds are generated.
AR-M236/M276/M237/M277 SIMULATION 8 - 48
Back up
Used to write the Flash ROM data to the SRAM.
FAX
Data
Check
FAX information print
FAX
Data
Item
USER SW.LIST User setting list
SOFT SW.LIST Soft SW list
SYSTEM ERROR System error list
Used to print the system error log (error
number and time).
PROTOCOL Protocol error list
Regardless of soft SW38-1 status, the
protocol monitor of the preceding
communication is printed. (Printing is
allowed at any time before starting the
next communication.) For this operation,
the protocol monitor of one
communication is always buffered.
Setting
Handset sound volume adjustment (Japan only)
FAX
Operation
Content