Sharp AR-M236 Service Manual page 60

24-6
Purpose Data clear
Function (Purpose) Used to clear the copy counter.
Item Counter
Operation/procedure
1. Press the [START] key.
The confirmation menu is shown.
2. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
24-7
Purpose Data clear
Function Used to clear the OPC drum (membrane decrease)
(Purpose) correction counter. (This simulation is executed when
the OPC drum is replaced.
Section Image process (Photoconductor/Developing/Transfer/
Cleaning)
Photo conductor
Item Counter
Operation/procedure
1. Press the [START] key.
The confirmation menu is shown.
2. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
24-9
Purpose Data clear
Function Used to clear the printer counter and other counters.
(Purpose) (The counter is cleared after completion of
maintenance.)
Section Printer
Item Counter
Operation/procedure
1. Select the counter to be cleared with the 10-key.
2. Press the [START] key.
The confirmation menu is shown.
3. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
Item
1 PRINTER Printer counter
2 IMC IMC counter
3 DUPLEX DUPLEX counter
4 OTHERS The other counters
Copier
Printer
Content
AR-M236/M276/M237/M277 SIMULATION 8 - 21
24-10
Purpose Data clear
Function (Purpose) FAX counter data clear
Section FAX
Item Counter
Operation/procedure
1. Select the "3: NUMBER OF PRINTS", and press the [START] key.
The confirmation menu is shown.
2. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
Item
1 FAX SEND FAX send page and time
(PAGE & TIME)
2 FAX RECEIVE FAX receive page and time
(PAGE & TIME)
3 FAX OUTPUT FAX output (number of prints)
Note: Executable only when the FAX is installed.
24-15
Purpose Data clear
Function Used to clear the scanner counter in the network
(Purpose) scanner mode.
Section Scanner section
Item Counter
Operation/procedure
1. Press the [START] key.
The confirmation menu is shown.
2. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
The scanner mode counter and the number of send of the scanner are
cleared.
* The simulation to perform communication with the PCL is inhibited
until Notice Page storing is completed. (Only when the serviceman
call error occurs.)
* When in other than the serviceman call error, entering the simulation
is not allowed from the system check display.
25
25-1
Purpose Operation test/check
Function Used to check the operation of the main drive
(Purpose) (excluding the scanner section) and to check the
operation of the toner concentration sensor. (The toner
concentration sensor output can be monitored.) (To be
supported for Ver.00.72 or later)
Section DRIVE
Item Operation
Content