Sharp AR-M236 Service Manual page 75

Item Setting range
1 AE 0-31
2 AE(TS)
46-31
Purpose Setting
Function Used to set the AE and the limit value in AE (Toner
(Purpose) save).
Operation/procedure
1. Touch the item to be adjusted.
The adjustment item and the currently set value are highlighted.
2. Enter the set value with the 10-key.
Item Setting range
1 AE
2 TEXT
3 TEXT/PHOTO 0 - 2
4 PHOTO
5 SUPER PHOTO
46-39
Purpose Setting
Function Used to switch the FAX send image quality.
(Purpose)
Enter the set value with the 10-key.
Item Content
0 HAIRLINE Original with pencil lines
and thin lines
1 PRINTER Printed original
Default
0
Default
1
Setting range Default
0 - 1
AR-M236/M276/M237/M277 SIMULATION 8 - 36
48
48-1
Purpose Adjustment
Function Used to adjust the copy mode magnification ratio (main
(Purpose) scanning direction, sub scanning direction).
Section Image processing
Item Picture quality
Operation/procedure
1. Touch the item to be set.
The item and the currently set value are highlighted.
2. Press the [START] key.
The display is shifted to the copy menu.
3. Select the paper feed tray and the print density, and enter the
adjustment value with the 10-key.
4. Press the [START] key.
Copying is started.
Item
1 F-R
2 SCAN
3 SPF/RSPF
(SIDE1)
4 SPF/RSPF
(SIDE2)
5 DUPLEX
Note: When this simulation is canceled, the display is shifted to the ini-
tial menu, but the machine is not reset.
48-2
Purpose Adjustment
Function Used to adjust the scanner mode magnification ratio
(Purpose) (main/sub scanning direction).
Section Image processing
Item Picture quality
Operation/procedure
0
1. Touch the item to be set.
The item and the currently set value are highlighted.
2. Press the [START] key.
The display is shifted to the copy menu.
3. Select the paper feed tray and the print density, and enter the
adjustment value with the 10-key.
4. Press the [START] key.
Copying is started.
Content
Main scanning magnification
ratio adjustment
Sub scanning magnification
ratio adjustment
SPF/RSPF surface sub scan
magnification ratio
SPF/RSPF back surface sub
scan magnification ratio
DUPLEX sub scanning
magnification ratio adjustment
Setting
Default
range
1-99 50
60
50