Attaching The Belt; Automatic Deactivation - Beurer EM 30 Instructions For Use Manual

– Batteries containing pollutants are marked with the following symbols:
Pb = battery contains lead,
Cd = battery contains cadmium,
Hg = battery contains mercury.
– Please dispose of the device in accordance with the directive
2002/96/EG – WEEE (Waste Electrical and Electronic Equipment). If you
have any queries, please refer to the local authorities responsible for
waste disposal.

Attaching the belt

Before each training session you should ensure that your skin is clean and free of creams or oils.
Only then can the device work optimally.
– Lay the belt down with the electrodes facing towards you.
– Moisten both electrodes and your stomach with water. Make sure the electrode surfaces are
evenly moistened to avoid high voltage points on your skin during subsequent training.
– Place the belt around your waist so that the electrodes are positioned on your stomach. Then
close the Velcro fastener.
The belt is made of an elastic material and fits a wide range of waist sizes. Take care that it is
tight enough for good contact between the electrode and skin, but does not constrict you.
Where must the belt not be used:
– On the head: here it can cause seizures
– On the neck / carotid artery: here it can cause cardiac arrest
– On the pharynx and larynx: here it can cause muscle spasms, which lead to
suffocation.
– Neat the ribcage: here it can increase the risk of ventricular fibrillation and lead
to cardiac arrest
Where must the belt only be used:
Only attach the belt around the stomach.
The navel should be covered at the center.

Automatic deactivation

If the device is not used after it is switched on, it switches off automatically after
5 minutes.
5. Use
General advice on training with the abdominal toning belt
In the first week you should not use the abdominal toning belt more than once a day to allow
your muscles to acclimatise slowly to the device. From then onwards you can train more fre-
quently.
navel
1
Pb Cd Hg