Beurer EM 30 Instructions For Use Manual page 11

9. Surface electrodes
10. Covers for electrode connection
If the self-adhesive covers for electrode connection are missing or become detached, we strongly
advise you to stick on the enclosed electrode covers.
Never attach the belt with bare metal electrodes. Use of the belt without electrode covers can
cause injury.
Description of the display symbols
A Battery status display:
B Intensity:
C Pause symbol:
D Timer:
E Key:
F Program:
4. Operation
Inserting batteries
A B
If the battery symbol in the display flashes, the batteries are flat and must be replaced. The ope-
rating unit must be removed from the holder on the belt to insert or replace batteries.
– Release the magnetic connector by pulling the device away from the belt.
The magnetic connector of the two contact buttons clicks out noticeably.
– Pull the device upwards out of the holder.
– Remove the battery compartment lid by pressing and sliding in the direction of the arrow.
– Insert the batteries observing the markings in the battery compartment. Ensure correct
battery polarity.
Note:
– Rechargeable batteries cannot be used for this device.
– If the device is not in use, we recommend keeping the device separate from the belt. If the
device is not needed for a long period, we recommend first removing the batteries.
– Used batteries do not belong in domestic garbage. You are legally obligated to dispose of
the batteries. Dispose of these through your electrical dealer or your local
recycling center.
flashes if the battery is flat.
set intensity levels 0 - 40
flashes if pause is activated
remaining time for the program started
key lock is activated
selected program with the number of training cycles already
completed
C D E
9
10
F
11