Advertisement
www.aeroplusrc.com
At the rear of the fuselage you will find a ply wood area, lay the CF gear on this and mark the 3 holes. Taking care to make sure it is straight.
Drill each hole with a fine drill and drop thin cyno into the holes to strengthen the wood.
Screw the CF gear on with the three supplied self taping screws.
Drill a hole in the base of the rudder for the rudder steering guide.
Before gluing with cyano, place it over the thin rod.
Aileron Servos
The ailerons on the wings are pre‐glued. Check each one by gently pulling to make sure that they are secure
Remove the covering where the aileron horns are glued in place. Use either a soldering iron or a sharp knife
Using sand paper rough the area that will be glued into the aileron.
Glue both horns in with epoxy glue, use a bolt through the horns when gluing to make sure the alignment is correct.
Fit the aileron servo and drill fine holes where the servo screws will fit. Then apply thin cyano to strengthen the holes.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
