Advertisement
www.aeroplusrc.com
Landing Gear Assembly
Push each axle through the whell holes, and tighten up with 1x self locking nut and 1x blind nut. Then axle though the hole of landing gear, and
tighten up with 1x self locking nut
The U/C rakes forward so use the correct wheel pant per side, and using a fine drill, drill holes for the screws.
Now line up the wheel in the centre of the wheel pant opening and tighten the collets. Remember to use nutlock and to make sure the wheel can
move freely.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
