Advertisement
www.aeroplusrc.com
Mount the ESC in airflow on the side of the electric motor mount, using a velco strap.
With the removal of the fuel tank it leaves a large area where the batteries can be mounted.
The cowl is fixed in 4 places, 2 at the top and 2 at the bottom. Place masking tape over the bottom 2 and pierce where the blind nut hole is.
Refit the cowl and drill where the marked hole was.
Switch
On each side of the fuselage near the canopy bolts are areas for switches to be mounted.
RX
A convienient place to mount the RX is just in front of the rudder servo. Ensure that it is mounted on velco and strapped down.
Set‐up
We highly recommend the use of both dual rates and exponential. This will allow the model to fly both precision and 3D at the flick of a switch.
Low Rates
Elevator 15‐20 deg
Ailerons 15‐20 deg
Rudder
25‐30 deg
For test flights always use low rates, remember that + and – exponential is different per manufacturer, check your TX manual.
Always check the range on your model before the maiden flight. Carry out a short flight then go over everything to make sure nothing has come loose.
Exponential
High Rate
15‐20 %
35‐45 deg
15‐20 %
35‐45 deg
15‐20 %
35‐45 deg
AeroPlus RC Copyright 2013 © All Rights Reserved
Exponential
45‐60 %
45‐60 %
45‐60 %
service@aeroplusrc.com
Advertisement
