Advertisement
www.aeroplusrc.com
Assemble the rudder servo control arm as below, drill holes for screws and use cyno to stop the nuts from coming loose.
Fit the rudder servo and drill holes using a fine drill for the servo screws, drop thin cyno into the holes to strengthen the wood.
Using servo screws fix the servo in place, note the spline is towards the front of the plane
The closed loop wires are assembled in the plane; attach the rear ball joints to the rudder. Do this to both sides.
Fit the arm onto the rudder servo and crimp the wires to a taut tension
Tail Gear
Locate all parts as in picture, when assembling remember to nutlock all parts
Assemble the Gear as per photo
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
